Product- GPS

We bring forth for our clients GPS Module, which is a third generation POT (Patch Antenna on Top). The equipment provides standard NMEA0183 strings in “raw” mode for any microcontroller. Our range is widely popular due to its reliable performance, high sensitivity and tracking capabilities in urban conditions. GPS Module provides information about current time, date, latitude, longitude, speed, altitude and travel direction / heading among other data. The range is used in navigation, tracking systems, fleet management, mapping and robotics.
The chipsets are designed by MediaTek Inc., one of the leading digital media solution providers and largest IC companies in Taiwan. Given below are some highlighting features of our products are given below:

• Requires no external components except power supply decoupling capacitors
• Available with RTC Back up battery
• Simplify the embedded system integration process
• Can be directly connected to Microcontroller's USART
• Can also be connected with external active antenna
• Supports upto 51 channels
• Appreciated for accuracy, integration, computing power and flexibility

Given below are the technical specifications of the product range:

• TTL asynchronous serial interface
• Low Power consumption: 55mA @ acquisition, 40mA @ tracking
• Single 3.3 VDC supply @ 55 mA (typical)
• Data output baud rate: 9600 bps (Default)
• Patch antenna size: 25mm x 25mm x 4mm
• Standard NMEA0183 output format
• Standard 8-pin header interface (.100" spacing)
• Based on MediaTek single chip architecture
  

This is a high gain  GPS Receiver (5V Serial) with 4pin 2.54mm pitch Berg strip. Receiver is made with  third generation POT (Patch Antenna On Top) GPS  module. The built in  3V3 to 5V level convertor  enable us to interface with normal 5V Microcontrollers. Its low pin count (4Pin) will make it easy to interface and it is bread board friendly (2.54mm connector). The 4 Pins are 5V, TX, RX, and GND. Yes, there is no setting required, just plug in to the power (5v), your data (NMEA 0183) is ready at TX pin ! This is a standalone 5V GPS Module and requires no external components .It is built with internal RTC Back up battery. It can be directly connected to Microcontroller's USART.

With the use high gain GPS engine providing a solution that high position and speed accuracy performances as well as high sensitivity and tracking capabilities in urban conditions & provides standard NMEA0183 strings in “raw” mode for any microcontroller. The module provides current time, date, latitude, longitude, speed, altitude and travel direction / heading among other data, and can be used in a host of applications, including navigation, tracking systems, fleet management, mapping and robotics.

The GPS chipsets inside the module are designed by MediaTek Inc., which is the world's leading digital media solution provider and largest fab-less IC company in Taiwan. The module can support up to 51 channels. The GPS solution enables small form factor devices. They deliver major advancements in GPS performances, accuracy, integration, computing power and flexibility. They are designed to simplify the embedded system integration process.

Features

• Single 5VDC supply @ 55 mA (typical) 
• TTL asynchronous serial interface
• Data output Baud rate: 9600 bps(Default)
• Standard NMEA0183 output format
• Standard 4-pin Berg strip interface (2.54mm Pitch). 
• Module will be provided with two type berg strip (Normal & Right angled)
• Based on MediaTek Single Chip Architecture.
• Patch Antenna Size: 25mm x 25mm x 4mm
• Low Power Consumption: 55mA @ acquisition, 40mA @ tracking
• L1 Frequency, C/A code, 51-channel
• High Sensitivity: Up to -158 dBm tracking, superior urban performances
• Position Accuracy: < 3m CEP (50%) without SA (horizontal)
• Cold Start is Under 36 seconds (Typical) 
• Warm Start is Under 34 seconds (Typical) 
• Hot Start is Under 1 second (Typical) 
• Max. Update Rate : 5Hz (Default: 1 Hz

The Mini Gmouse GPS Receiver (RS232) is a low cost High sensitivity GPS module + Internal Antenna with PS2 Style connector. It is a Stand alone GPS receiver providing a solution that high position and speed accuracy performances as well as high sensitivity and tracking capabilities in urban conditions .Just Power the module with 5V, you will get GPS data in Standard NMEA Protocol format with current time, date, latitude, longitude, altitude, speed and travel direction/heading among other data.

The GPS chipsets inside the module are designed by MediaTek Inc., which is the world's leading digital media solution provider and largest fab-less IC company in Taiwan. The module can support up to 66 channels. The GPS solution enables small form factor devices. They deliver major advancements in GPS performances, accuracy, integration, computing power and flexibility. They are designed to simplify the embedded system integration process. The module is the best choice for you to design the GPS related products.

Features

• Asynchronous RS232 serial interface : 9600bps 
• Standard NMEA0183 Protocol format  
• Single +5VDC supply @ 60mA (typical) 
• Standard PS2 interface .
• Cable Length : 2M 
• L1 frequency, C/A code, 66-channel
• Embedded LNA and SAW filter
• High sensitivity : Up to -165dBm tracking, superior urban performance1
• Position accuracy : < 3m CEP (50%) without SA (horizontal)
• Cold Start is Under 35 seconds (Typical) 
• Warm Start is Under 34 seconds (Typical) 
• Low power consumption : 48mA@ acquisition, 38mA@ tracking
• DGPS(WAAS, EGNOS, MSAS) support (optional by firmware)
• Update rate : 1Hz (Default)
• RoHS compliant
  

We bring forth for our clients GPS Module, which is a third generation POT (Patch Antenna on Top). The equipment provides standard NMEA0183 strings in “raw” mode for any microcontroller. Our range is widely popular due to its reliable performance, high sensitivity and tracking capabilities in urban conditions. GPS Module provides information about current time, date, latitude, longitude, speed, altitude and travel direction / heading among other data. The range is used in navigation, tracking systems, fleet management, mapping and robotics.
The chipsets are designed by MediaTek Inc., one of the leading digital media solution providers and largest IC companies in Taiwan. Given below are some highlighting features of our products are given below:

• Requires no external components except power supply decoupling capacitors
• Available with RTC Back up battery
• Easy to use
• Usb output
• Simplify the embedded system integration process
• Can be directly connected to Microcontroller's USART
• Can also be connected with external active antenna
• Supports upto 51 channels
• Appreciated for accuracy, integration, computing power and flexibility

  Given below are the technical specifications of the product range:

• Low Power consumption: 55mA @ acquisition, 40mA @ tracking
• Single 3.3 VDC supply @ 55 mA (typical)
• Data output baud rate: 9600 bps (Default)
• Patch antenna size: 25mm x 25mm x 4mm

HOLUX GR-87 is a high performance, low power consumption, small size, very easy integrated GPS module designed for a broad spectrum of OEM system applications. This product is based on the proven technology found in other HOLUX 20 channel GPS receivers and SiRFstar III chipset solution. The GPS module will track up to 12 satellites at a time while providing fast time-to-first-fix and one-second navigation updates. Its far reaching capability meets the sensitivity requirements of car navigation as well as other location-based applications. Therefore, HOLUX GR-87 module is very fit to the customers who devote themselves to AVL system integration and location-based service.

The GR-87 design utilizes the latest surface mount technology (BGA) and high level circuit integration to achieve superior performance while minimizing space and power requirements. This hardware capability combined with software intelligence makes the board easy to be integrated and used in all kinds of navigation applications or products. The application system may communicate with the module set via two RS232 compatible bi-directional communication channels with CMOS/CMOS 3V voltage level.

  Features:

• Build on high performance SiRF StarIII chipset.
• Average Cold Start time and under 45 seconds.
• Low power consumption
• 20 channels “All-in-View” tracking.
  
• 200,000+ effective correlators for fast TTFF and high sensitivity acquisitions
  
• Integrated ARM7TDMI CPU with software engineering services and available for embedded customer defined applications.
• On chip 1Mb SRAM.
• Dual TTL level serial ports with one for GPS receiver command message interface, another one for RTCM-104 DGPS input.
• Compact Board Size 1"x1"x0.27"(25.4x25.4x7mm) for easy integration into hand-held device.
• Reacquisition Time 0.1 seconds
• Support Standard NMEA-0183 and SiRF Binary protocol
• Support Accurate 1PPS Output Signal Aligned with GPS Timing
• Multi-path Mitigation Hardware
• On-board RTCM SC-104 DGPS and WAAS /EGNOS Demodulator
• Built-in a lithium battery make GPS fast positioning
  

Description: GPS external active antenna series is designed to work in perfect harmony with MTK GPS module. Featuring water proof design for use in tough terrain and environment, it maximizes the potential of GPS module by bringing exceptional GPS signal reception performances. This module comes in SMA connector format with 2.5 meter length. In addition, they come with embedded magnet at the bottom for easy mounting on top of automobiles.

Features:

• Central Frequency: 1575.42 MHz +/- 2MHz
• Polarization: R.H.C.P
• Gain: 27dB +/0 1dB
• Input Voltage: 3V to 5V
• Water-proof Design
• Embedded Magnet for easy mounting
• 2.5M Cable with SMA Connector

Specifications:

• Central Frequency fo: 1575.42 MHz +/- 2MHz
• Bandwidth (min.): 9MHz
• Operating Temperature: -20 to +85 °C
• Storage Temperature: -50 to +120 °C
• Relative Humidity: 0% to 100%