Send Email
Send SMS

Rajguru ElectronicsRajguru Electronics
Send Email
Send SMS


Our Products










Home » Our Products » Stepper Motor

Stepper Motor

Creating a niche of Stepper Motor such as Stepper Motor Driver A4988, Stepper Motor Driver Drv8825, Microstepping Driver M542, Microstepping Driver M860 and MA860H - 2 Phase Analog Stepper Drive at its best, with utmost quality.


Stepper Motor Driver A4988

Stepper Motor Driver A4988
Approx. Price: Rs 200 / Piece

The A4988 stepper motor driver carrier is a breakout board for Allegro’s easy-to-use A4988microstepping bipolar stepper motor driver and is a drop-in replacement for the A4983stepper motor driver carrier. The driver features adjustable current limiting, over current protection, and five different microstep resolutions. It operates from 8 – 35 V and can deliver up to 2 A per coil.

This product is a carrier board or breakout board for Allegro’s A4988 DMOS Microstepping Driver with Translator and Over current Protection; we therefore recommend careful reading of the A4988 datasheet (380k pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to2 A output current per coil (see the Power Dissipation Considerations section below for more information).
Here are some of the driver’s key features:
•Simple step and direction control interface
•Five different step resolutions: full-step, half-step, quarter-step, eighth-step, and sixteenth-step
•Adjustable current control lets you set the maximum current output with apo tentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
•Intelligent chopping control that automatically selects the correct current decay mode(fast decay or slow decay)
•Over-temperature thermal shutdown, under-voltage lockout, and crossover-current protection
•Short-to-ground and shorted-load protection (this feature is not available on the A4983)Like nearly all our other carrier boards, this product ships with all surface-mount components—including the A4988 driver IC—installed as shown in the product picture.We also sell a larger version of the A4988 carrier that has reverse power protection on the main power input and built-in 5 V and 3.3 V voltage regulators that eliminate the need for separate logic and motor supplies.




Stepper Motor Driver Drv8825

Stepper Motor Driver Drv8825
Approx. Price: Rs 250 / Piece(s)

The DRV8825 stepper motor driver carrier is a breakout board for TI’s DRV8825 microstepping bipolar stepper motor driver. The module has a pinout and interface that are nearly identical to those of our A4988 stepper motor driver carriers, so it can be used as a higher-performance drop-in replacement for those boards in many applications. The DRV8825 features adjustable current limiting, overcurrent and overtemperature protection, and six microstep resolutions (down to 1/32-step). It operates from 8.2 – 45 V and can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (rated for up to 2.2 A per coil with sufficient additional cooling).

General specifications
Minimum operating voltage:8.2 V
Maximum operating voltage:45 V
Continuous current per phase:1.5 A2
Maximum current per phase:2.2 A3
Minimum logic voltage:2.5 V4
Maximum logic voltage:5.25 V4
Microstep resolutions:full, 1/2, 1/4, 1/8, 1/16, and 1/32

Features:

1. Simple step and direction control interface

2. Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step

3. Can interface directly with 3.3 V and 5 V systems

4. Over-temperature thermal shutdown, over-current shutdown, and under-voltage lockout

5. Short-to-ground and shorted-load protection

6. 4-layer, 2 oz copper PCB for improved heat dissipation

7. Exposed solderable ground pad below the driver IC on the bottom of the PCB

 




Microstepping Driver M542

Microstepping Driver M542
Approx. Price: Rs 3,200 / Piece(s)

The M542 is an economical microstepping driver based on patented technology of Leadshine. It is suitable for driving 2-phase and 4-phase hybrid stepping motors. By using the advanced bipolar constant-current chopping technique, it can output more speed and torque from the same motor, compared with traditional drivers, such as L/R drivers. Its 3-state current control technology allows coil currents to be well controlled and with relatively small current ripple, therefore less motor heating is achieved.

Electrical Specifications (Tj = 25oC/77oF)
ParametersM542
Min.TypicalMax.Unit
Output Current1.0-4.2(3.0RMS)A
Supply Voltage203650VDC
Logic Signal Current71016mA
Pulse Input Frequency0-300kHz
Isolation Resistance500--Mohm

Key Features
  • Extremely cost-effective
  • Good high speed performance
  • Supply voltage up to 50VDC
  • Output current up to 4.2A
  • Pulse frequency up to 300 KHz
  • Automatic idle-current reduction
  • 3-state current control technology
  • Self-adjustment technology
  • Pure-sinusoidal current control technology
  • TTL compatible and optically isolated input
  • 15 selectable resolutions in decimal and binary, up to 25,600 steps/rev
  • Suitable for 2-phase and 4-phase motors
  • DIP switch current setting with 8 different values
  • Support PUL/DIR and CW/CCW modes
  • Short-voltage, over-voltage, over-current protections
  • Small size (118x75.5x33mm)




Microstepping Driver M860

Microstepping Driver M860
Approx. Price: Rs 6,500 / Piece

The M860 is a high performance microstepping Drive based on pure-sinusoidal current control technology. Owing to the above technology and the self-adjustment technology (self-adjust current control parameters) according to different motors, the driven motors can run with smaller noise, lower heating, smoother movement and have better performances at higher speed than most of the Drives in the markets. It is suitable for driving 2-phase and 4-phase hybrid stepping motors.

Specification:
General :
ParametersM860
MinTypicalMaxUnit
Output current1.8-7.2 (5.1 RMS)A
Supply voltage246880VDC
Logic signal current71016mA
Pulse input frequency0-300KHz
Isolation resistance500

Features:
  • High performance, cost-effective
  • Supply voltage up to 72VDC
  • Output current up to 7.2A
  • Self-adjustment technology
  • Pure-sinusoidal current control technology
  • Pulse input frequency up to 300 KHz
  • TTL compatible and optically isolated input
  • Automatic idle-current reduction
  • 16 selectable resolutions in decimal and binary, up to 51,200 steps/rev
  • Suitable for 2-phase and 4-phase motors
  • Support PUL/DIR and CW/CCW modes
  • Short-voltage, over-voltage, over-current and short-circuit protection.


MA860H - 2 Phase Analog Stepper Drive

MA860H - 2 Phase Analog Stepper Drive
Approx. Price: Rs 6,500 / Piece

The MA860H is a high performance microstepping drive based on pure-sinusoidal current control technology. Owing to the above technology and the self-adjustment technology (self-adjust current control parameters) according to different motors, the driven motors can run with smaller noise, lower heating, smoother movement and have better performances at higher speed than most of the drives on the markets. It is suitable for driving 2-phase and 4-phase hybrid stepping motors.


Features

  • Extremely cost-effective
  • Good high speed performance
  • Supply voltage up to 80VAC or +110VDC
  • Output current up to 7.2A
  • Self-adjustment technology
  • Pure-sinusoidal current control technology
  • Pulse input frequency up to 300 KHz
  • TTL compatible and optically isolated input
  • Automatic idle-current reduction
  • 16 selectable resolutions in decimal and binary, up to 51,200 steps/rev
  • Suitable for 2-phase and 4-phase motors
  • Support PUL/DIR and CW/CCW modes
  • Short-voltage, over-voltage, over-current and short-cicuit protection

Electrical Specifications
(Tj =25oC/77oF)

 

Parameters

MA860H

Min

Typical

Max

Unit

Output current

1.8

-

7.2 (5.1 RMS)

A

Supply voltage

36

48

80

VAC

+50

+68

+110

VDC

Logic signal current

7

10

16

mA

Pulse input frequency

0

-

300

KHz

Isolation resistance

500

 

 

MO


 




 



Rajguru Electronics
Dileep Jain (Manager)
399 3rd Floor , Manek Chambers , Above Vasant Bhavan Restaurant, Lamington Road
Mumbai - 400004, Maharashtra, India

Contact via E-mail

Contact via SMS


Home  |  Profile  |  Our Products  |  Site Map  |  Contact Us

Member IndiaMART.com © Rajguru Electronics. All Rights Reserved (Terms of Use)
Developed and Managed by IndiaMART InterMESH Limited