Send Email
Send SMS

Rajguru ElectronicsRajguru Electronics
Send Email
Send SMS

Our Products

Home » Our Products » Zigbee & XBee Module

Zigbee & XBee Module

Our organization is reckoned as the most prominent suppliers and traders of XBEE Transreceiver. The range we offer under this category comprises XBee 2mW Wire Antenna - Series 2, Xbee 1mW Wire Antenna - Series 1, XBee Pro 63mW Wire Antenna - Series 2B (ZigBee Mesh), XBee Explorer USB, XBee Explorer - Serial. All our offered are highly in compliance with the set industrial standards and are stringently tested under well defined parameters before delivering. Clients can avail these modules in desired specifications at market leading prices.

XBee 2MW Wire Antenna - Series 2C

XBee 2MW Wire Antenna - Series 2C
Approx. Price: Rs 1,050 / Piece(s)

Item Code: XB24-Z7WIT-004

Bee ZB / ZigBee modules provide cost-effective wireless connectivity to devices in ZigBee mesh networks. Utilizing the ZigBee PRO Feature Set, these modules are interoperable with other ZigBee devices, including devices from other vendors. The most common factor in determining whether to use ZB is the potential need to tie-in with other ZigBee-compatible networks or mesh networking. If this is not a requirement, the series 1 802.15.4 modules may be perfectly suitable for your project.


  • Low-power module uses only ~33 mA to transmit
  • Indoor range of 200 feet, or outdoors up to 4000 feet line-of-sight
  • Supports binding and multicasting for home automation
  • 15 general-purpose I/O lines
  • Industry-leading sleep current of sub 1µA

Application Ideas:

  • Remote Industrial Control and Monitoring
  • Long range remote control
  • Wireless data acquisition
  • Wireless networking

Key Specifications

  • Digital I/O: 15
  • ADC Channels: (4) 10-bit ADC inputs
  • Data Rate: RF 250 Kbps, Serial up to 1 Mbps
  • Range: Indoor 200 ft (60 m), Outdoor (LOS) 4000 ft (1200 m)
  • Transmit Power: 3.1 mW (+5 dBm)
  • Channels: 16 channels
  • Encryption: 128-bit AES
  • Voltage requirements: 2.1 to 3.6 VDC
  • Current requirements: ~33 mA @ 3.3VDC (transmit), ~28 mA @ 3.3VDC (receive), <1 uA @25ºC (sleep)
  • Communication: CMOS UART / SPI @ ~3.3V
  • Dimensions: 1.087" L x 0.960" W x 0.16" H (27.61 x 24.38 x 4.06 mm)
  • Operating temperature range: -40 to +185 °F (-40 to +85 °C)

Note: Because XBee modules have 2 mm pin spacing, we recommend one of our adapter boards for each module. Our adapter boards provide several advantages to the XBee modules such breadboard-friendly standard 0.1 inch pin spacing, mounting holes, and easy-to-solder connections. Even if you are communicating point-to-point without a PC, we still recommend that you always have at least one XBee USB Adapter Board (# 32400) so you can easily configure and test each XBee module prior to putting it in a point-to-point application.

    Xbee 1mW Wire Antenna - Series 1

    Xbee 1mW Wire Antenna - Series 1
    Approx. Price: Rs 1,150 / Piece(s)

    Item Code: XB24-AWI-001

    Description: This is the Xbee 1mW Wire Antenna - Series 1 XB24-AWI-001 module from Digi. It is Easy to use. Just power up and start communicating. Digi XBee 802.15.4 modules are the easiest-to-use, most reliable and cost-effective RF devices we’ve experienced. The 802.15.4 XBee modules provide two friendly modes of communication – a simple serial method of transmit/receive or a framed mode providing advanced features. XBees are ready to use out of the package, or they can be configured through the X-CTU utility or from your microcontroller. These modules can communicate point to point, from one point to a PC, or in a mesh network.

    You only need to choose an antenna style (PCB or wire) and power level (1 mW for up to 300 ft). The PCB antenna version provides a lower profile footprint for applications with limited space while the wire antenna version allows for more flexibility in adjusting for optimal range at the same output power.


    Key Features:

    • Outdoor range up to 300 feet (90 m) line of sight
    • Indoor range up to 100 feet (30 m)
    • Data rate up to 250 Kbps
    • 2.4 GHz frequency band (accepted world-wide)

    Note: Only series 1 modules can work with series 1 type modules you cannot mix up series 1 and series 2 modules to setup communication.

    Xbee Pro S1

    Xbee Pro S1
    Approx. Price: Rs 2,100 / Piece(s)

    This is the Pro (higher-power) version of the popular XBee! This module is series #1 (802.15.4 protocol) 60mW wireless module, good for point-to-point, multipoint and convertible to a mesh network point. These are much more powerful than the plain XBee modules, great for when you need more range.

    What we like about the Series 1 modules is that they are so easy to get set up. If you have two in range, they will automatically form a serial link with no configuration, so you can send TTL serial data back and forth. You can also configure the baudrate, as well as sleep modes, power modes and tons more stuff using the Digi XBee tool.

    The pins on an XBee are 2mm spacing, not 0.1" so they will not fit into a breadboard. For that reason, they work best in our XBee adapter module kit (which has a 250mA 3.3V regulator) or with the USB XBee adapter.

    This module comes with a wire antenna, its the same price as a chip antenna but 50% more range because of the improved antenna.

    XBee Pro 63mW Wire Antenna - Series 2B (ZigBee Mesh)

    XBee Pro 63mW Wire Antenna - Series 2B (ZigBee Mesh)
    Approx. Price: Rs 1,900 / Piece(s)

    Item Code: XBP24-BZ7WIT-004

    Description: This is the XBee Pro 63mW Wire Antenna XBP24-BZ7WIT-004 module from Digi. The new Series 2B improves upon the power output and data protocol of the Pro Series2. Series 2B modules allow you to create complex mesh networks based on the XBee ZB ZigBee mesh firmware. These modules allow a very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! Point to point and multi-point networks are supported. Series 2B modules use a different hardware configuration from the earlier models and while they will communicate with Series 2 XBee modules, they are not compatible with the outdated Series 2.5 Modules.


    • 3.3V @ 295mA
    • 250kbps Max data rate
    • 63mW output ( 17dBm)
    • 1 mile (1600m) range
    • Wire Antenna
    • Fully FCC certified
    • 6 10-bit ADC input pins
    • 8 digital IO pins
    • 128-bit encryption
    • Local or over-air configuration
    • AT or API command set

    Note: Series 1 and Series 2B XBee modules have the same pin-out. However, Series 1 modules cannot communicate with Series 2B modules.

      XBEE Explorer - Serial

      XBEE Explorer - Serial
      Approx. Price: Rs 200 / Piece(s)

      Zigbee/Xbee modules available from Digi work on 3.3v and are difficult to interface to a controller. This Zigbee/Xbee Xplorer Serial is very simple to use and using this base board you will be able to connect the zigbee module directly to the PC. You can also interface the Zigbee/Xbee module to microcontroller for which you will require a MAX232 IC in your circuit. All you have to do is provide a 9-12V AC/DC supply and you are ready to go. You can use this module for Xbee Series 1, Xbee Series 2, Xbee PRO as well as for Tarang Modules.



      XBEE Explorer USB

      XBEE Explorer USB
      Approx. Price: Rs 300 / Piece(s)

      Item Code: XBEE-Explorer-USB

      Interfacing Board used to interface ZigBee wireless Module with Desktop or Laptop computer systems.With the aid of our XBEE Explorer USB customers can easily communicate between PC to PC or PC to embedded boards. These Explorer are highly suitable for changing the modules of varied devices using PC through USB port. This Explorer works with all XBee modules including the Series 1 and Series 2.5, standard and Pro version. We have equipped the adapters with five indicator LED's for depicting the status of the data being received or transmitted, power, signal strength of the recipient and other associated data. As ZigBee communicates through Serial Communication so other end of USB which is connected to PC, treated as COM port for Serial Communication. It is provided with indication LEDs for ease.




      Rajguru Electronics
      Dileep Jain (Manager)
      399 3rd Floor , Manek Chambers , Above Vasant Bhavan Restaurant, Lamington Road
      Mumbai - 400004, Maharashtra, India

      Contact via E-mail

      Contact via SMS

      Home  |  Profile  |  Our Products  |  Site Map  |  Contact Us

      Member © Rajguru Electronics. All Rights Reserved (Terms of Use)
      Developed and Managed by IndiaMART InterMESH Limited