Ph Sensor Module with Ph Probe - ADIY

Ph Sensor Module with Ph electrode Probe by ADIY Also Known as Analog pH Sensor Kit is specially designed for Arduino controllers.This pH Sensor Kit has a built-in simple,convenient, and practical connection and features. It has an LED which  works as the Power Indicator, a BNC connector, and a PH2.0 sensor interface. To use this Ph sensor kit, just connect the pH sensor with the BNC connector, and plug the PH2.0 interface into the analog input port of any Arduino controller. If pre-programmed, you will get the pH value easily.Comes in a compact plastic box with foams for better mobile storage.

 

Instruction for use: 

    Instructions for use: Place the PH Sensor probe vertically and keep it for a long time before using. The Device will give excellent results if the sensor probe is used multiple times in the period of 2 to 3 days. Rinse the sensor probe tube in deionized water and dab it with the tissue paper before immersing it in the test solution. The device will take approximately 30 to 40 seconds to stabilize and give the results. Before placing the probe in the storage solution make sure to rinse the probe tip in the deionized water, dab it with the dry tissue paper and then place it in the storage cap.